LEMAN RAD310-RAD310T Manual De Instrucciones página 84

Adjustment of the table
Loosen the clamping lever of the table and adjust the thicknessing table to the required height
by hand operated wheel. Put the working piece on the table, placing the un-machined side
upwards. Lift the table into such a height until it stops at working piece. Using the
hand-operated wheel set the stock removal (chip) at a max of 2.5mm. Then affix the table to the
required position using the clamping lever. Switch on the machine and push the workpiece
forwards. Workpieces with differently shaped ends have to be always inserted its wider end.
When planing pitchy wood, it is recommended to coat slightly the thicknessing table with
paraffin wax for easier moving.
Work area
While thicknessing stand in front of the planing table and on that side where is the hand-wheel
(for lifting up the thicknessing table).
Safety instruments
When working with circular saw, spindle moulder, planer and thicknesser, the operator must
wear short strengthened apron and safety goggles. It is suitable to use adequate protection of
hearing and recommended working footwear. It is forbidden to use working mantle.
Workers qualification
Only authorized worker specialized in woodworking branches (or worker instructed by this
specialist) is allowed to work with the machine. Operators are liable to abide with all safety
instruction and regulations, which are valid in his country.
１２
EN