Tabla de contenido
Idiomas disponibles
Idiomas disponibles
6. Rotate the Base magnetic clamp activation lever by 60° into the ON position. Always check to make sure
the lever springs into the locking notch.
7. Check for a secure and strong hold of the magnetic contact area to the workpiece and that no excessive air
gap exists.
8. Rotate the Pivoting magnetic clamp activation lever by 60° into the ON position. Always check to make
sure the lever springs into the locking notch.
9. Check for a secure and strong hold of the magnetic contact area to the workpiece and that no excessive air
gap exists.
Important
DO NOT allow other ferromagnetic materials within 2 inches of any exposed ACTIVATED magnetic
contact area. Serious injury could occur from instantaneous magnetic attraction!
10. When the application is complete, deactivate the magnetic clamps and remove the Variable Angle Clamp
from the workpieces, especially if the application might exceed the Maximum Operating Temperature of
the magnet clamp. To deactivate the magnetic clamp, first lift the activation lever at its far end upwards to
disengage the lever from its latching notch (1) and return by 60° into the OFF position (2). Care must be
taken because the activation lever can quickly/strongly spring back to the OFF position when working on
thin materials.
Mounting Options (1) with Clamping Levers and (2) with Clamping Screws
7
Tabla de contenido
