MAGLOGIX MX-750-VA Manual De Instrucciones página 10

Maintenance and Inspection of the Variable Angle Clamp
Regular maintenance and inspections are necessary to ensure the safe use and operation of the Variable Angle
Clamp. Furthermore, country-specific standards and regulations must be observed depending upon user
application.
The below maintenance intervals are classified according to the recommended schedule.
Before every use...

visually inspect the magnetic clamps for any damage.

clean both magnets magnetic contact areas of any contamination (i.e. rust, metal chips) that would cause
unevenness of attachment or an air gap between the workpiece.
Weekly...

make sure the activation levers are not bent or the plastic of the activation lever is not cracked.

make sure both activation levers springs into their locking notch when in the ON position.

inspect the magnetic contact area of both magnetic clamps for any protruding scratches, pressure point
deformations, and/or cracks into the magnetic contact area. Have the magnet repaired by the manufacturer
if any unevenness of the magnetic contact areas is identified.
Monthly...

check the markings and labeling on the magnets for legibility, damage, modification, or removal. To meet
full compliance, the entire Variable Angle Clamp must be returned to the manufacture for calibration and relabeling.
Annually...

have the load-bearing capacity of the magnets checked by the supplier or an authorized workshop, should
the application so require.
Unauthorized repairs or modification to the Variable Angle Clamp are not permitted.
If you have any questions, please contact the manufacturer.
10