Idiomas disponibles
Idiomas disponibles
o the
not around the tummy. Don't use
chors
force-bearing points without
them
markings.
splay
Don't use the support leg when
green
using the adult seat belt
ctors
THREE-POINT CAR SEAT BELT
, the
46. Retract the support leg and store
e red
it in the base.
47. Place the child in the safety seat,
irmly
adjust the headrest to the correct
f the
position, with the guide hook
seat
slightly higher (1-2 cm) than the
ure it
child's shoulders, then pass the
diagonal seat belt through the
at in
green guide under the headrest.
tion,
The lap belt must go through the
ith a
green hook and both seat belts
ining
should pass through the green
guide under the armrest. Click the
e the
metal parts into the buckle of the
alled,
car seat belt. Check that the belt
is not twisted and tighten the seat
seat,
belt by pulling the diagonal belt
orrect
upwards. Check that the lap belt
hook
is positioned as low as possible,
n the
across the thighs and not around
ss the
the tummy.
h the
48. Press the button to activate the
drest.
SIP and, once the safety seat has
ough
been installed, close the car door.
belts
Don't use force-bearing points
green
without markings.
Click
49. In order to easily place the
kle of
child in the child safety seat,
at the
pass the seat belts through the
en the
gonal
special elastic bands on the sides,
t the
as shown in figure 49.
ow as
Don't use the support leg when
s and
using the adult seat belt.
R388_CRONO_(KX 115)_Libretto_v5ok.indd 41
R388_CRONO_(KX 115)_Libretto_v5ok.indd 41
REMOVING THE COVER
50. Remove the inner padded pillow
and shoulder pads.
51. Remove the headrest cover:
guide the tension at the hook.
Once the belt is detached, take
off the fabric cover.
52. Remove the fabric cover from the
body of the safety seat: clip the
body of the safety seat open
and remove the fabric cover.
It is suitable for use until the
baby is 60 cm tall.
MAINTENANCE
Store the harness away and remove
the padding. Take the fabric cover
off the headrest. Unfasten the
button and remove the fabric cover
from the lower part of the headrest.
To fit the fabric cover again, follow
the same steps in reverse order. If
the following occurs, the safety
lock will not function properly:
• When the red button is pressed,
it opens slowly.
• It is not possible to insert the
metal parts of the safety lock into
the fastener or, when inserted,
they automatically detach.
• The safety button does not make a
click sound.
• It is difficult to insert the metal
parts into the safety lock.
• Excessive force is required to open
the safety lock. The five-point
safety harness is very important
for the child's safety. Incorrect
use of the five-point harness may
put the child's safety at risk.
41
10/11/23 14:11
10/11/23 14:11
