Primus TUPIKE Manual De Instrucciones página 13

5. In transportation mode, the pan support
rough sides are uppermost, towards the pot. Ensure that the metal pins on the edges sit in the
holes in the drip tray.
6. Attach the gas cartridge to the regulator by screwing with a definite continuous motion as far as it
will go. Do this manually – DO NOT USE a pair of pliers, or similar.
7. Make sure that the gas cartridge is level with the regulator upwards. Check that no gas is leaking
from the connection between the regulator and the gas cartridge. Use soapy water as discussed
in the section "Before ignition" if you are unsure.
LIGHTING THE STOVE.
circumstances move the stove when it is lit, either with or without pots.
If, due to the wind, the flames are forced down under the burner, turn
the stove off and move it to a more sheltered location.
1. Rotate the gas supply knob
wise and press the ignition button
2. If the burner does not ignite after five attempts with the ignition button, turn off the supply
(clockwise as far as it will go) and wait ten seconds for the unignited gas to dissipate. Turn on the
gas supply and try again.
3. Once the gas has been lit, you can adjust the flame and the supply of heat with the supply knob.
The gas should burn directly upwards with a steady flame.
4.
Put the pot or frying pan on the stove after the gas has been lit.
5.
If you need to use two burners, light the second one the same way that you lit the first.
is upside down. Turn the pan support so that the
for the burner you want to light, about one turn anti-clock-
next to the knob to ignite the gas.
Important: Under no
EN