BGS technic 3287 Manual De Instrucciones página 6

ATTENTION
During operation safety goggles and gloves should always be worn to
guard against flying rust and chips.
Always wear hearing protection during operation this air tool for a longer time.
Use only cutting discs rated at 12.000 RPM or higher.
.
Lubrication and maintenance
Lubricate the air motor daily with a good grade of air motor oil. If no air line oil is used run a teaspoon
of oil through the tool. The oil can be squirted into the tool air inlet (B) Figure 2. or into the hose at the
nearest connection to the air supply, then run the tool. A rust inhibitive oil available from auto supply
stores etc. is acceptable for air motor. Other factors outside the tool may cause loss of power or
erratic action. Reduced compressor output, excessive drain on the ir line, moisture or
restrictions in air pipes or the use of hose connection of improper size or poor condition may reduce
air supply. Grit or gum deposits in the tool may cut power and may be corrected by cleaning the air
strainer and flushing out the tool with gum solvent oil or an equal mixture of SAE #10 oil and
kerosene. If outside conditions are in order, disconnect tool from hose, disassemble tool, replace
worn or damaged parts, clean, reassemble and relubricate or take tool to your nearest authorized
service center.
SW-Stahl und Werkzeugvertriebs GmbH
L e v e k r u s r e t S a r s s e 6 5
D 4 - 2 8 9 7 R e m s c h e d i
Tel. +49 (0) 2191 / 46438-0
F ax +49 (0) 2191 / 46438-40
- E M a : l i n i o f @ s w s a t l h d . e