Hilti EXO-T-22 Manual De Instrucciones Original página 30

3. If the following conditions are met, also take this action:
Conditions: The power tool you want to attach is resting on the ground or on some other firm surface.
▶ Press the Down button to unreel enough load-bearing cable from the EXO­T­22 to attach the power
tool without having to lift it yourself. Alternatively, pull the carabiner down slowly to unreel the
load-bearing cable.
Note the maximum length of the load-bearing cable.
▶ Engage the hook of the EXO-T-22 in one of the two eyelets of the holder.
▶ Press the Up button. Do not manually assist the lifting operation.
▶ The attached power tool is lifted.
▶ Allow the attached power tool to dangle at the desired height for approx. 2 seconds.
▶ The weight of the attached power tool is automatically registered and initialized.
▶ If the user intervenes prematurely by pulling or lifting, the weight will not be correctly initialized
and the attached power tool might be lowered or raised automatically.
The power tool, with all accessories and accessory tool, should be hanging as close to the
horizontal as possible. If the attached power tool tilts too far in one direction, use the other eye
of the holder. In this case, the weight of the attached power tool then has to be re-initialized.
4. If the following conditions are met, also take this action:
Conditions: The power tool to be attached has to be hooked in while held in mid-air.
▶ Press the Down button to unreel the desired length of load-bearing cable.
Make sure there is a clear drop of at least 15 cm below the power tool to be attached.
▶ Engage the hook of the EXO-T-22 in one of the two eyelets of the holder.
▶ Abruptly drop the power tool. The EXO­T­22 detects the sudden acceleration and brings the attached
power tool to a stop within a few centimeters.
▶ Allow the attached power tool to dangle at the desired height for approx. 2 seconds.
▶ The weight of the attached power tool is automatically registered and initialized.
▶ If the user intervenes prematurely by pulling or lifting, the weight will not be correctly initialized
and the attached power tool might be lowered or raised automatically.
▶ Press the Up button or the Down button if the attached power tool is not correctly initialized after
being dropped.
You can also lock the load-bearing cable before you attach the power tool. The power tool is
then initially suspended at a constant height. Then press the Up button or the Down button.
The attached power tool moves accordingly and at the same time its weight is registered and
initialized.
The power tool, with all accessories and accessory tool, should be hanging as close to the
horizontal as possible. If the attached power tool tilts too far in one direction, use the other eye
of the holder. In this case, the weight of the attached power tool then has to be re-initialized.
6.4 Working with the EXO­T­22
After the EXO­T­22 has registered and initialized the weight of the attached power tool, the power tool is
always held suspended at the height at which you position it.
1. To have the equipment raise the attached power tool, lift the power tool slightly.
▶ The EXO­T­22 registers the reduction in weight and reels in the load-bearing cable, raising the power
tool accordingly.
2. To have the equipment lower the attached power tool, press the power tool gently down.
▶ The EXO­T­22 tool detects the increase in weight and slowly unreels the load-bearing cable
accordingly.
3. To stop the movement, cease applying vertical force to the attached power tool.
4. To prevent the load-bearing cable from being reeled in or unreeled, simultaneously press the Up button
and the Down button and hold them down.
▶ The LED status indicator flashes green.
▶ The load-bearing cable is locked.
24 English 2375781
*2375781*