Idiomas disponibles
Idiomas disponibles
Checks to be performed before connecting
+
Make sure that both parts of the trimmer (A) are
together. Both indicators on the top must be aligned;
otherwise turn the gear wheel to adjust (DO NOT
FORCE ENTRY).
Make sure the leaf collector bag (G) is correctly attached at the
+
outlet of the collector (B) with the help of the rubber band.
Condition of the raw material to process
The condition of the material to be processed is very important. The MT Tumbler 200 has been designed to work with most varieties
and is capable of processing large amounts. Nevertheless, the way that the machine is used and the condition of the material to be
processed must be properly considered.
The MT Tumbler 200 has been designed to work with wet or dry owers (11-15% moisture content). If you want to trim dry owers,
you must t a speci c barrel. Contact us if you want to trim dry.
How to use the machine
Take the following aspects into account before use:
+
Inclination
+
Loading speed
+
The time that the ower will remain in the barrel
+
Speed of the barrel
+
Speed of the blade
+
Aspiration
To work with only one MT Tumbler 200 it's advisable to install the machine on a level and at surface. Add about one handful
of owers every 30 seconds*. The time in the barrel will be between 30-45 seconds. When adding additional material for
processing, the owers that are already inside the barrel will be discharged.
*The loading rate will vary depending on the conditions of your material.
To work with two or three units of the MT Tumbler 200 it's necessary to use the rails and adjust the inclination of the tandem
according to the conditions of the product and the variety to process.
Quality control
Check the appearance of the owers when leaving the barrel. If the owers are not clean enough, this is usually because:
+
The aspiration is too slow (the leaf collector is dirty/blocked).
+
The cutting blade is not properly adjusted.
+
The machine is dirty. It will need maintenance.
+
The spacing between the blade and the barrel is not correct.
The owers have not been in the barrel for long enough. You are probably adding owers too quickly. The machine works best
+
when the barrel is half-full.
Maintenance
For the best results, it is essential to regularly maintain the machine. Follow the disassembly and cleaning instructions below:
See a video on Youtube of
the MT Tumbler 200 working.
See a video on Youtube of
the MT Tumbler 200 Full System working
SLIGHTLY ROTATE
THE PINION
19
