Idiomas disponibles
Idiomas disponibles
• Route all cables so that there is no risk of
tripping.
• Always pull directly on the plug when
disconnecting the cable, never on the cable
itself.
• If the product is to be operated outdoors, it
may be operated only in protected outdoor
areas.
Warning
• The device may only be operated on a 230
V 50 Hz AC voltage network. Work on the
230 V network must only be carried out by
an electrician certi ed in your country. The
applicable accident prevention regulations
must be adhered to.
• To avoid an electric shock from the device,
please disconnect the mains voltage (switch
off the automatic circuit breaker). Failure to
comply with the installation instructions can
cause res or other hazards.
Note
The light source for this
light is exchangeable.
Note
The ballast unit of this
light is exchangeable.
Warning
Never look straight into the light source and
do not aim its beam of light straight into the
eyes of other people or animals.
This could damage your/their eyes.
Risk of electric shock
• Do not open the product and do not
operate it if it is damaged, if smoke, a
strange smell or loud noises are coming
from it. Immediately contact your dealer or
our service department (see item "Service
and Support").
• Do not use the product if the
AC adapter, the adapter cable or the mains
cable are damaged.
• Do not attempt to service or repair the
product yourself. Leave any and all service
work to quali ed experts.
Warning
• Only operate the product from an approved
socket that is connected to the public
power supply. The socket must be installed
close to the product and must be easily
accessible.
• Disconnect the product from the power
supply using the On/Off switch – if this is
not available, unplug the power cord from
the socket.
• If using a multi-socket power strip, make
sure that the total power consumption of
all connected devices does not exceed the
socket strip's maximum throughput rating.
• If you will not be using the product for a
prolonged period, disconnect it from mains
power.
5. Shortening the LED strip
Warning
Only shorten the LED strip at the marked
points (see Pic 1)
6. Installation
• Proceed step-for-step in accordance with the
illustrated (installation) instructions.
• Pull the backing lm off the LED strip to
secure it using the self-adhesive reverse.
5
