Idiomas disponibles
Idiomas disponibles
MAINTENANCE
Your tool will last longer and perform better if periodic maintenance is
performed. Please use the information below to keep your tool operating in
top condition.
Lubrication
Disconnect tool from the air supply and remove all
fasteners. Apply 2 - 3 drops of air tool oil (provided)
in the air inlet two - three times a day. If the tool will
be used outside in the winter, use a winter grade
air tool oil to help keep frost from forming inside
the tool. Do not use other types of lubricants on
this tool, as other lubricants may contain chemicals
harmful to o-rings and other tool components.
Drain compressor tanks and hoses daily.
Cleaning
Disconnect tool from the air supply and remove all fasteners. Brush tool
off using a parts cleaning brush or clean rag. Open E-Z Clear latch and
magazine cover, and brush out dirt and debris. Check area around trigger
and workpiece contact, and clean as necessary.
Trigger Check
Check trigger operation daily to confirm proper sequential operation:
1. Move the selector button on the trigger to the rear position.
2. Press the workpiece contact against a safe work surface without
depressing the trigger. THE TOOL MUST NOT CYCLE.
3. Hold the tool above a safe work surface and pull the trigger
with out depressing the workpiece contact. THE TOOL MUST NOT CYCLE.
4. Pull and hold the trigger, and then press the workpiece contact
against a safe work surface. THE TOOL MUST NOT CYCLE.
5. With finger off trigger, press the workpiece contact against a safe
work surface. Keep tool pressed against work surface, and pull
trigger. THE TOOL MUST CYCLE ONCE.
6. The trigger must return to the normal position each time finger
pressure is released.
13
MAINTENANCE
