Beurer IH 57 Instrucciones De Uso página 53

3. Pour a sufficient amount (3-6 ml) of tap water (soft water) into the medication container
the cover. Shake the container slightly so that the remaining fluid mixes properly with the cleaning fluid.
4. Open the cover of the medication container, pour out all the liquid and then add enough tap water
(soft water) again.
5. Place the medication container on the housing
6. Press and hold the On/Off switch
cator will then flash orange quickly and the device will go to self-cleaning mode. The device will
5
automatically run for 3 minutes. Please make sure there is sufficient fluid in the medication container.
Disinfection
Please carefully observe the points below when disinfecting your medication container
atomiser set. Regular disinfection of the individual parts is recommended.
First, clean the medication container
continue with the disinfection.
IMPORTANT
Make sure that you do not touch the mesh if possible, as this can destroy it.
Disinfection with ethyl alcohol (70 – 75%)
• Pour 8 ml of ethyl alcohol into the medication container
in the container for at least 10 minutes.
• For better disinfection, shake the unit gently back and forth.
• Once this is complete, pour the ethyl alcohol out of the container.
• Repeat the process, but this time using water.
• Position the medication container
from the outside. Leave this to work for 10 minutes.
• Finally, clean all parts again with water.
• The same procedure is used for the mouthpiece
.
3
for 3 seconds when the device is switched off. The LED indi-
4
and atomiser set as described in the "Cleaning" section. Then
2
so that you can drip a few drops of ethyl alcohol onto the mesh
2
11 and the masks
53
. Close the container. Leave the alcohol
2
.
9 10
. Then close
2
and the
2