Idiomas disponibles
Idiomas disponibles
Toselecta pile height setting:
Turnoffvacuum
cleaner. Select a pile height
setting by tilting the vacuum cleaner back
until front wheels are lifted slightly off the
floor.
Slide the adjustment lever to the correct
setting.
There are tour (4) pile height settings on the
vacuum cleaner. Use the LOW setting for
most low-pile carpets and bare floor
cleaning (with agitator OFF), and the HIGH
setting for high-pile carpets like shag carpet,
scatter rugs, etc. Use the other settings as
needed for carpet heights in-between low
and high pile.
CAUTION
Do not allow vacuum cleaner to
remain in one spot for any length
of time when the agitator is turn-
ing. Damage to carpet may occur.
SOME MODELS
Bare floor setting:
Slide the carpet/bare
floor selector all the way back and down
toward the bottom of the nozzle until it
locks into place.
In this position
the brush assembly does
not revolve.
This setting should
be used
for cleaning
hardwood
and tile floors and
when any attachments
(tools)
are
used.
Carpet
setting:
Slide the selector
all the
way forward
and up to the carpet
position.
In this position
the brush assembly
will
turn. When carpets
are being cleaned
the
selector
should
be in this position.
Attention:
Refer to your carpet
manufac-
turers cleaning
recommendations.
Some
more delicate
carpets may require that
they be vacuumed with the agitator
turned
off, to prevent
carpet damage.
!
CAUTION
Do not allow vacuum
cleaner
to
remain
in one spot for any length
of time when the agitator
is turn-
ing. Damage
to carpet may occur.
Note:
For longer belt life, turn the vacuum
cleaner
off before moving selector, other-
wise make sure the selector
is pushed
fully
and quickly
as possible
to the
desired
position.
Failure to do so can
cause the belt to rub on the selector
shaft
and may result in the belt becoming
hot
and creating
a burning rubber smell.
Carpet/Bare
Floor Selector
To Bare Floor
Position
To Carpet
Position
7
