Idiomas disponibles
Idiomas disponibles
CORD ASSEMBLY
Make sure the quick release
upper cord
I-3ookis in the upright position. Remove
the wire tie from the power cord.
Lock the power cord
into the locking notch
base by pressing it
into the quick release
upper cord hook as
shown. This helps
keep the power cord
out from under the
vacuum cleaner agi-
tator.
Power
Wrap the power cord around the upper
and lower cord hooks and lock the power
cord plug onto the power cord.
Quick Release
Lower
HANDI-MATE JR.®
For operation of Handi-Mate
Jr.® see
separate Owners Manual.
La_h_
__
TO INSERT HANDI-MATE
JR®
Place the rear of the Handi-Mate Jr.® into
the caddy. Rotate the Handi-Mate Jr.®
back until it snaps into place.
TO REMOVE
HANDI-MATE
JR.®
Rotate Handi-Mate Jr.® out of the caddy.
OPERATING
INSTRUCTIONS
l
1. Turn the
Release
Upper Cord
quick release
Hook
upper cord
hook to either
side and down
to release the
power cord.
WARNING
• To reduce the risk of electric shock,
this vacuum cleaner has a polarized
plug (one blade is wider than the
other).
• The plug will fit in a polarized
outlet
only one way. If the plug does not fit
fully
in the outlet, reverse the plug. If
it still does not fit, contact a qualified
technician
to install the proper outlet.
Do not change the plug in any way.
2. Detach the power cord plug from the
power cord and pull the cord off the quick
release upper cord hook. Be sure the power
cord is still locked into the locking notch of
the upper cord hook.
3. Be sure the vacuum cleaner has bag
installed. See DUST BAG REPLACEMENT.
4. Plug the polarized power cord into a 120
Volt outlet located near the floor.
5. To replace cord, turn upper hook counter-
clockwise pointing up, then wrap cord.
WARNING
6
Injury and Product Damage
Hazard
• DO NOT place hands or feet under
the unit at any time.
• DO NOT use outlets above coun-
ters. Damage from cord to items in
urroundin
area could occur.
