Idiomas disponibles
Idiomas disponibles
2. Remote control battery installation
AA batteries
Open the battery cover and insert the 3 AA batteries correctly according to the electrode instructions.
(Batteries not included)
NOTES:
1. Make sure the battery are loaded correctly according to the polarity indications on the battery
compartment.
2. Please do not mix old and new batteries together.
3. Please do not mix different types of batteries together.
SIGNAL CONNECTION OF TRANSMITTER AND RECEIVER
1. Turn on the drone and place it on a level surface, the indicator light of the transmitter and the LED of
the drone flashing.
2. Push the throttle joystick to the highest point then push back to the lowest point, and when you hear
two beeps, the indicator light of the transmitter and the LED of the drone become normally on, and the
signal connection is completed.
TRANSMITTER CALIBRATION
Apply transmitter calibration when the drone fails to take off vertically. Press the "One button
calibration" button when the lights of the drone are on and then start flashing and keep it on again, the
calibration is complete, and the drone must be placed on a horizontal surface in a steady state when
the calibrations are conducted.
16
