Maintenance And Storage - WolfPack DT2211 Manual De Instrucciones

5.3 OPERATION
• Always direct the cable to the rear away from the appliance.
• If a cord becomes damaged during use, disconnect the supply cord from the mains
immediately. DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPLY.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
• When using an extension cord, it shall not be lighter than H05VV-F 2x 1.0mm²).
• Do not carry the appliance by the cable.
• Disconnect the appliance from the mains supply
- whenever you leave the machine;
- before clearing a blockage;
- before checking, cleaning or working on the appliance;
- if the appliance starts to vibrate abnormally.
• Operate the appliance only in daylight or in good artificial light.
• Do not overreach and keep your balance at all times.
• Always be sure of your footing on slopes.
• Walk, never run.
• Keep all cooling air inlets clear of debris.
• Never blow debris in the direction of bystanders.
• It is recommended to operate the machine only at reasonable hours - not early in the
morning or late at night when people might be disturbed.
• It is recommended to use rakes and brooms to loosen debris before blowing/vacuuming.
• It is recommended to slightly dampen the surface in dusty conditions or use a mister
attachment.
• It is recommended to use the full blower nozzle extension so that the air stream can work
close to the ground.

5.4 MAINTENANCE AND STORAGE

• Keep all nuts, bolts and screws tight to be sure the appliance is in safe working condition.
• Check the debris collector frequently for wear or deterioration.
• Replace worn or damaged parts.
• Use only genuine replacement parts and accessories.
• Store the appliance only in a dry place.
5.5. REPAIRS
• Your power tool should be repaired by a qualified specialist using only standard
replacement parts. This will ensure that you meet the required safety standards.
34