JENN-AIR JGC8430 Manual De Instalación página 10

BURNERIGNITION AND AUTO-REIGNITION
This applianceis equippedfor electronicauto-reignitionby means of a
spark igniterlocatedat the rearof each burner.The burnersaredesigned
tolightat anyvalverotation that admitssufficientgasflowto supportaflame
andto automaticallyretight f ollowinga loss offlame dueto a draft or other
adversecondition.This feature is providedas a convenienceand is not
intendedas a safetyfeature.
CAUTION: Never use a metal blade to pry off a control knob. tf a knob
cannot be easily removedtuck the folds of a cloth dishtowelunder and
aroundthe knoband pull the towel upwardwith steadyeven pressure.
CAUTION:Nevercover controlknobsor surroundingcontrolsurfacewith
utensils,towels, or otherobjects.Neverobstructfree air passagepastthe
controlknobs.The knobopeningshavebeensized to properlycontrolair
entry to the interiorof the applianceduringoperation.
This appliance has no air shutters. Primary air adjustments are
unnecessary. Theburnersaredesignedto provideoptimumaerationforall
gases without air shutters. When operating properly, burners should
produceclearlydefined,evenblueflames. If theflameshaveyellowtips or
are hazy andotherwiseappearto haveinsufficientair,obtainthe services
of a qualifiedservicetechnician.
Specifiedinputrates are as shownin figures16 and 17, below.
4 BURNER MODEL
BURNER
LOCATION
Right Front
Right Rear
Left Front
Left Rear
FIGURE16
INPUT RATES- NATURALGAS(BTU/HR)
Hi Lo
12,000 1,500
9,100 1,100
6,500 850
10,500 1,500
6 BURNER MODEL
FIGURE17
BURNER
LOCATION
Right Front
Right Rear
CenterFront
CenterRear
Left Front
Left Rear
INPUT RATES- NATURALGAS (BTU/HR)
Hi Lo
12,000 1,500
9,100 1,100
6,500 850
6,500 850
9,100 1,100
10,500 1,500
HOLDING UNIT DOWN TO COUNTERTOP
Positionthe cooktopin the cutout opening. Pre-threadhold down bolts
approximately2 inches into hold-downstraps. (2 each suppliedwith
4-burner model,4 eachsupplied with 6-burnermodel).Opencabinetdoors,
then reachup undercooktopand install hold-downbracketsinto slots in
eachendof burnerbox(seefigure18).Thetopof eachbracketshouldhook
intotheslot asshown.(Repeat f or frontand rearof6 burner-burner model.)
Tighten the bolt in each bracketto snug the unit top down against the
countertop.Seefigure 19. DO NOTOVERTIGHTEN.
(BOTH ENDS)
FIGURE18
COUNTERTOP
BURNER BOX
HOLD-DOWN
STRAP
FIGURE19
REQUIRED ADJUSTMENTSAT TIME
OF INSTALLATION
The installationof this appliancemustconformwith localcodes,or in the
absenceof local codes,with the latest editionof the National FuelGas
Code ANSI Z223.1 USA or current CAN/CGA-B149INSTALLATION
CODE.
Thisappliancewas manufactured for usewith NaturalGas.If LPgas
isthefuelofchoice,followtheconversion to LP procedure foundin the
installationinstructions.
Testall externalconnections for gas leaks.Nevertest for gas leaks
with an openflame.
D Testall electricalconnections.
10