Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Place the cutting blade onto the feed screw shaft with the blade facing the front as
illustrated (fig.4). If it is not fitted properly, meat will not be ground.
Place the desired cutting plate next to the cutting blade, fitting protrusions in the slots
(fig.5).
Support or press the centre of the cutting plate with one finger then screw the fixing
ring until tight with another hand (fig.6). Do not over tighten.
Place the hopper plate on the head and fix into position.
Locate the unit on a firm place.
The air passage at the bottom and the side of the motor housing should be kept free
and not blocked.
MINCING MEAT
Cut all foods into pieces (Sinewless, boneless and fatless meat is recommended,
approximate size : 20 mm x 20 mm x 60 mm) so that they fit easily into the hopper
opening.
Feed foods into the hopper plate. Use only the food pusher (fig.7).
After use switch the unit off and unplug it from the power supply.
P-4
Tabla de contenido
