HAEGER Digi Desumi 16 DE-D16.013A Instrucciones De Uso página 20

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
Dehumidifier does not
dry the air as it should.
The dehumidifier
makes loud noise when
operating.
Dehumidifier operates
continuously.
Overflow of water on
floor.
Room humidity is low.
The air filter is dirty.
ls the air inlet or air outlet
obstructed?
The dehumidifier size is too small
for application.
Poor air circulation.
Do not allow enough time to
remove the moisture.
The room has not been sealed
properly.
Room temperature is too low, or
below 41°F (5°C). The machine will
not work or undergo poor
dehumidifying efficiency in low
temperature.
The dehumidifier is not positioned
levelly.
ls there blocking around the air
inlet? The air filter is clogged.
Is the filter installed correctly?
Check if the dehumidifier is in
Continuous Mode.
Room humidity is too high.
Doors and windows are open.
Hose to connector or hose
connection may be loose.
The water tank has not been
installed properly.
The float of water tank has been
stuck.
18
The dehumidifier is designed
to work in the humidity range
of 30%-80%. Above or below
this range, it will not work.
Clean the air filter.
Remove the obstruction from
the air inlet or outlet.
Increase the quantity of
dehumidifier. Or change to a
higher capacity dehumidifier.
Please leave about 20cm (7.9
inches) around the product.
Allow enough time to remove
the moisture. When first
installed, allow at least 3-4
days to maintain the desired
RH.
Check that all doors, windows
and other openings are
securely closed.
Please wait until the
temperature rises to above
41°F (5°C) or higher.
Move the machine to a
horizontal position.
Clean up the dirt or lint on
the air outlet and intake.
Please check whether the
packing bag of the filter had
been removed and the filter
has been installed correctly.
Do Not set the humidity too
low. Typically, 40-50% are
good for use.
Change humidity settings. Or
change to a higher capacity
dehumidifier.
Ensure that all doors,
windows and other openings
are closed.
Connect the hose with the
drainage port tightly.
Re-install the water tank
properly.
Move the float and let it
swing freely.
loading