Idiomas disponibles
Idiomas disponibles
1. Pull the water tank out from the bottom with both of your hands.
2. Invert the water tank to empty the water.
3. Put the water tank back in place, the water full indicator will go out.
Note:
•
Do not remove the float from the water tank. If the float in the water tank is removed,
the sensor may not be able to determine the water level stored in the tank properly
that may lead to water overflow leak from the water tank.
•
If the water tank is dirty, just use cold water or warm water to clean it. Do not use
detergent, steel wool, chemically treated dust cloth, gasoline, benzene, thinner or
other solvents. Otherwise, it may damage the water tank and cause it to leak.
•
When placing back the water tank, use your hands to press the tank back in its place.
If the water tank is not placed properly, sensors or protections from water overflow
may not operate as expected.
Take off the
water tank cover
Continuous Drainage
Pull out the power supply, take out the water tank, open the drainage cap, remove the
black rubber plug, insert the water hose into the continuous drainage port and push it back
into the water tank.
Connect the power supply to start the operation. The water outlet of the water hose
should be lower than the continuous drainage port by more than 10 cm (3.9 inches), and
the water hose cannot be bent.
Water tank
14
Float
