Before Use; Operation - cecotec WINDROID 870 CONNECTED T Manual De Instrucciones

ENGLISH

2. BEFORE USE

- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent product damage when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Technical Support Service of Cecotec
immediately.
Box contents:
- Conga WinDroid 870 Connected T window cleaning robot
- Power adapter and power cord
- Remote control
- Safety rope
- 12 cleaning cloths made of microfiber
- Instruction manual
- App manual
1. Check if the safety rope is broken or the knot is loose. Fasten the safety rope and tie to
indoor fixture before operating the device.
2. Make sure the battery is fully charged (green light indicator on).
3. Turn the robot on before putting it onto the glass. Once on the glass, make sure it remains
stuck before letting it go.
4. Remove anything on the glass.
Warning
Before using the remote control, remove the insulation spacer at the bottom back side of the
remote control. To remove or change the batteries, just slide the battery cover downwards.
Warning
It is advisable to monitor the window cleaning robot's operation to ensure it is working
properly. If you want to clean peculiar surfaces and don't know if the window cleaning robot
will work properly, be extra vigilant and take precautions. Remember that the safety rope must
be always used.
The Conga WinDroid 870 Connected T is designed to clean all types of windows, shop windows,
and standard vertical, flat surfaces. However, for safety reasons, it is recommended not to use
the window cleaning robot under the following circumstances:
- On rimless glass.
46 CONGA WINDROID 870 CONNECTED T
- On curved glass, whether concave or convex.
- In glass less than 3 mm thick.
- On glass panes that have a joint (silicone or rubber) between the frame and the glass with
the following characteristics: if the joint has an angle (ɑ) of less than 45° and its distance
at the edge (lb) is greater than 5 mm. The window cleaning robot may lose suction and
fall. If your window joints fit these characteristics, do not use the window cleaning robot.

3. OPERATION

Important
The window cleaning robot must be always plugged to a mains socket during operation.
Connection Fig. 3
- Connect the power cord to the power supply and then to the robot.
- Tighten the power connector as shown in figure 3.
Power button
- Press and hold the power button for 2 seconds to turn the window cleaning robot on and
off.
- While in operation, press the power button to pause or start cleaning.
How to place the Conga WinDroid robot on the glass/window
- Switch on the window cleaning robot and make sure the fan starts up.
- Place the window cleaning robot on the glass or window. Keep it 10 cm away from the
window frame.
- Make sure the window cleaning robot remains firmly attached to the glass before releasing
it.
How to remove the Conga WinDroid robot from the glass/window
- Once finished cleaning, hold the safety rope with one hand and detach the window cleaning
robot from the glass with the other.
- Press the power button to turn off the window cleaning robot once placed on a safe
surface.
Note:
Secure the window cleaning robot firmly during this process.
UPS (Uninterrupted Power System) function
- The safety system activates for 30 minutes when the power supply is cut off, this way
preventing the window cleaning robot from immediately falling to the floor.
ENGLISH
CONGA WINDROID 870 CONNECTED T 47