Idiomas disponibles
Idiomas disponibles
Robot clean area
Stick the virtual device firmly on the floor. Please do not paste a virtual wall near the
charging based, so as not to affect recharge.
Key indicator status description
Error Tones and Indicators
Status
Roller brush stuck
Anti-drop
sensors are dirty
Side brush failure
Side wheel failure
Forward collision
bumper stuck
Suction failure
Low battery
Seven beeps, solid orange light
warning
How to turn off the robot
Turn off the power button on the bottom side of the robot (turn the gear to " OFF " state)
Magnetic stripe
virtual wall
Double-sided tape
Blue
Red
Red flashes
Orange
Orange flashes
Buzzer alarm
One beep, flash red light
Two beeps, solid blue light
Two beeps, flash red light
Three beeps, flash red light
Four beeps, solid blue light
Five beeps, flash red light
Robot clean area
3
2
1
4 4
Normal power, can enter working mode/standby mode as
required
Error warning
Error warning
In low battery stat at working mode/standby mode/return to
charging base
The appliance is charging
Turn off Sweeva s and remove any hair or debris from the roller
'
brush.
Clean the anti-drop sensors.
Turn off Sweeva s and remove any hair or debris from the side
'
brushes.
Turn off Sweeva s and remove any hair or debris from the wheel.
'
After repairing the stuck forward collision bumperpress the
" start button " to restart the robot.
1.Turn off Sweeva s, then remove and empty the dust collector.
'
2.Make sure the suction inlet is not blocked by any hair or debris.
Manually put the robot to the charging base for charging.
- 13 -
Restricted area
Action
EN
