Bosch GSB18V-1330C Instrucciones De Funcionamiento Y Seguridad página 14

Variable Speed Controlled
Trigger Switch
Your tool is equipped with a variable speed trigger
switch. The tool can be turned "ON" or "OFF" by
squeezing or releasing the trigger. The speed can be
adjusted from the minimum to maximum nameplate
RPM by the pressure you apply to the trigger. Apply
more pressure to increase the speed and release
pressure to decrease speed (Fig. 1).
Forward/Reversing Lever &
Trigger Lock
After tool use, lock trigger in
" O F F " p o s i t i o n to h e l p
prevent accidental starts and accidental discharge.
Yo u r t o o l i s e q u i p p e d w i t h a f o r w a r d /
reversing lever and trigger lock (16) located above the
trigger (Fig. 8). This lever was designed for changing
direction of rotation of the bit, and for locking the
trigger in an "OFF" position.
For forward rotation, (with chuck pointed away from
you) move the lever to the far left (Fig. 8).
For reverse rotation, move the lever to the far right
(Fig. 8).
To activate trigger lock, move lever to the center off
position.
Gear Shifting
Your tool is equipped with two separate gear ranges,
low gear 1 and high gear 2. Low gear provides high-
torque and slower drilling speeds for heavy duty work or
for driving screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide switch (7),
to the high 2 or low position 1 (Fig. 9).
ATTENTION: If your tool appears to be running, but the
chuck will not turn, check to make sure the gear shifter
is pushed fully into desired setting.
Operating Instructions
complete stop. Shifting during rotation of the chuck can
cause damage to the tool.
FIG. 8
(16)
14
Do not change direction of
rotation until the tool comes to a
FIG.9
(16)
(7)