Bosch GSB18V-1330C Instrucciones De Funcionamiento Y Seguridad página 11

Disconnect battery pack from tool before making any assembly, adjustments or changing
accessories. Such preventive safety measures reduce the risk of starting the tool accidentally.
Inserting Bits
Move reverse switch lever to the center "OFF" position.
Remove battery pack and turn the mode selector switch
to the drilling
sleeve counter-clockwise viewing from chuck end, and
open chuck to approximate drill bit diameter. Insert a
clean bit up to the drill bit flutes for small bits, or as far
as it will go for large bits. Close chuck by rotating the
chuck sleeve clockwise and securely tighten by hand
(Fig. 3). Move forward / reverse switch lever to desired
position.
Do not use the power of the
drill while grasping chuck to
loosen or tighten bit. Friction burn or hand injury is
possible if attempting to grasp the spinning chuck.
Belt Clip
When the tool is attached to
the belt, position yourself to
avoid entanglement with surrounding objects.
Unexpected entanglement could cause the tool to fall
resulting in injury to the operator or bystanders.
The belt clip accessory (11) will allow you to
conveniently attach your tool to your belt. This feature
will allow you to have both hands free when climbing a
ladder or moving to another work area.
The belt clip can be attached to either side of the tool by
securing it with a mounting screw. Always make sure you
securely tighten the mounting screw before use (Fig. 4).
To use clip, turn tool upside down and attach to your
belt.
Assembly
position. Rotate the chuck
FIG. 3
CHUCK SLEEVE
DRILL BIT
BIT HOLDER
SCREWDRIVER BIT
11
CLOSE
OPEN
FIG. 4