Tabla de contenido
14
22
42
4-10
4-11
Operation
5.2.3 Settings
After switching on the unit, a default weight mode is
shown. If the unit then shows another weight mode,
5.3 and 5.4.
The unit of measurement indicated at power up is
inches, but the setting selected before switching off
for grams / ounces remains.
5.2.3.1
Changing the Dimensions Unit
Default diameter and width unit setting: inches.
• Press the "mm" or "inch" icon (14, Fig. 4-10).
The measuring unit changes to the possible alternative.
5.2.3.2
Changing the Weight Unit
Default weight unit setting: grams.
Proceed as follows to change the weight unit, whether
you have already spun the wheel or not.
• Press the key "g" or "oz" icon (22, Fig. 4-11).
The measuring unit changes to the possible alternative.
5.2.4 Shutting down
Always shut down properly when work is complete:
• Remove the and hub nut and the wheel from the
balancer.
• Remove the cones from the stub shaft. Check the
surfaces (internal and external) of the cones for
damage. The condition of the cone is very important
for a good balance quality.
• Store the cones and the hub nut in the correct place.
• Check the thread of the hub nut and stub shaft.
• Clean all threads and surfaces with a dry, soft cloth.
• Unplug the mains cable from the power outlet.
• Check the power cable for damage or wear.
• Tidy up the storage areas.
• Clean the display and input panel with a soft, dry
cloth.
• Check that the balancer is only resting on its own
three feet. Remove old wheel weights taken off and
any other materials from under the balancer.
ounces
Tabla de contenido
