Tabla de contenido
M4x8 (4x)
1
2
3
134
iii-4
iii-5
4
iii-6
iii-7
Installation
Fitting and connecting the monitor
Fig. iii-4 VESA support
The 4 screws needed (M4x8) to fix the VESA support
to the monitor are part of the kit supplied.
Fix the VESA support to the monitor.
Figure iii-5 monitor power Supply
Fix the power supply to the back of the machine
using the Velcro strip provided.
Fig. iii-6 Connection of monitor and PC
Caution
Before connecting the electronic cables turn off the
mains switch.
Insert the monitor connector into the right socket
(2) of the embedded unit.
Insert the connector USB (3) into the PC and the
monitor.
Insert the monitor main connector (4) into the
socket.
Plug in the plug (1, Fig.iii-5) of the power supply
cable.
Figure iii-7 Monitor Cables
Fix the monitor cables to the supporting pole using
the clips supplied, leaving enough at the top to allow
the monitor to turn freely, as shown.
iv Test procedures
• Balance a wheel to less than 0.25 oz. (5 grams) per
• Balance a wheel to less than 0.25 oz. (5 grams) per
plane.
plane.
• Perform a User Calibration.
v Instructing the operator
(Following applies only if a unit is installed by a service
Technician)
• Show and explain the Safety Booklet.
• Show the operator how to switch the unit on and
off.
• Show the operator how to perform an emergency
stop.
• Show the operator how to select a wheel type, enter
data and apply a weight.
6.2.
Tabla de contenido
