Idiomas disponibles
Idiomas disponibles
List of approved sealing rings and discs
Please take the time to carefully read through these operating instructions to ensure that you are familiar with all of the functions
of your MasterEx Lite-Ex PL 30 and know how to use all of the functions. For you own safety and information please read through the
information on the following pages.
1 - Housing head
2 - Sealing rings 39x1,5
3 - Torch head
4 - Sealing rings 30x2
5 - Twist ring
6 - body of torch
7 - battery compartment
8 - Alignment screw
9 - Sealing rings 35x2
10 - Spare disc
In order to be able to use the torch in the Ex-area, you must first check that the outer housing head and body are screwed on
completely. After this has been done, you can switch on the torch by turning the yellow twist ring slightly in a clockwise direction. The
torch is supplied with factory-fitted batteries.
When the brightness is no longer satisfactory, the batteries should be replaced. It is strongly recommended that all three batteries
be replaced together. When replacing the batteries, only use approved battery types (see table of approved battery types in section 7.
Technical data).
To replace the batteries, hold on to the housing head and the twist ring, and turn the body of the torch anticlockwise until it comes off.
Take the used batteries out of the battery compartment, observing correct polarity and replace them with new ones. After you insert the
new batteries screw the body of the torch back on. Make sure that torch components are screwed together securely before switching the
torch on.
battery replacement
- Only use approved battery types. See table in section 7. Technical data.
- Always replace all of the batteries together.
- Make sure that the polarity of the inserted batteries is correct.
- Please ensure that all used batteries are properly disposed of in an environmentally friendly manner.
- After changing the batteries or the sealing rings always check to make sure that the sealing rings and threads are clean and in good
condition.
A non-contacting twist ring is used to switch on the MasterEx Lite-Ex PL 30 (see description above). Dirt or moisture does not effect the
function. The twist ring is easy to clean if excessive amounts of dirt and grime have made it difficult to turn. First take off the torch body
and remove the batteries (see section 8.3 Battery replacement). Remove the twist ring by sliding it off the back of the torch, and then
clean the ring. When putting the twist ring back on, make sure that the arrow marks on the ring line up with the alignment screw on the
bottom part of the torch head (see illustration 1). Then re-insert the batteries, and screw the body of the torch back on.
The MasterEx Lite-Ex PL 30 is equipped with an extremely long-lasting LED lamp. Replacing the LED is normally not required. If,
however, the torch is defective or the brightness of the torch has diminished, it should be sent to the manufacturer for inspection or
-14-
Manufacturer
8. Functional description / operating information
8.1. MasterEx Lite-Ex PL 30 components
1
4
3
2
8.2 Getting started
8.3 battery replacement
8.4 Cleaning the twist ring
8.5 Lamp replacement
Type
sealing rings type PL 30 (complete set)
spare disc type PL 30
5
7
8
9
10
6
