SICK GLD20 Instrucciones De Funcionamiento página 40

OPERATING INSTRUCTIONS
en
8 Disposal
9 Maintenance
40 O P E R A T I N G I N S T R U C T I O N S | GLD20
LED/fault pattern
Yellow LED flashes
Signal interruptions when
object is detected
The sensor must be disposed of in line with applicable country-specific regulations.
When disposing of them, you should try to recycle them (especially the precious met‐
als).
NOTE
Disposal of batteries, electric and electronic devices
• According to international directives, batteries, accumulators and electrical or
electronic devices must not be disposed of in general waste.
• The owner is obliged by law to return this devices at the end of their life to the
respective public collection points.
•
WEEE: This symbol on the product, its package or in this document,
indicates that a product is subject to these regulations.
This SICK sensor is maintenance-free.
We do, however, recommend that the following activities are undertaken regularly:
• Clean the optical interfaces and housing
• Check the fittings and plug connectors
Cause
Sensor is still ready for oper‐
ation, but the operating condi‐
tions are not ideal
Depolarizing property of the
object surface (e.g., tape),
reflection
Measures
Check the operating condi‐
tions: Fully align the beam
of light (light spot) with the
reflector. / Clean the optical
surfaces (sensor and reflec‐
tor)./ If the potentiometer is
set to the max. sensing range:
Reduce the distance between
the sensor and the reflector,
and check the reflector type /
Reflector is not suitable for
the application in question
(we recommend only using
SICK reflectors) / Check sens‐
ing range and adjust if neces‐
sary. / Distance between the
sensor and the reflector is too
long
Reduce sensitivity or change
the position of the sensor
8026844.1K1V/2024-02-08 | SICK
Subject to change without notice