Idiomas disponibles
Idiomas disponibles
6
Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1
Switching on
The metal construction screwdriver starts running as soon as it is pressed lightly against the working
surface. The running speed can be controlled smoothly right up to maximum speed by varying how
far the control switch is pressed in.
▶ Switch the tool on.
6.2
Switching on in sustained operating mode
The lockbutton can be pressed in while the control switch is pressed. The metal construction
screwdriver then runs in sustained operating mode. The lockbutton makes the tool less tiring to use
as the control switch does not have to be constantly pressed.
▶ Switch on in sustained operating mode.
6.3
Switching off after sustained operation
In order to be able to switch off from sustained operating mode quickly at any time, keep your hand
close to the control switch. Pressing the control switch again causes the lockbutton to jump back into
its original position.
▶ Switch off after sustained operation.
6.4
Removing screws
Remove the depth gauge or screw guide, if fitted. Set the forward / reverse switch to the "Reverse"
position.
▶ Remove the screws.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Carefully clean the air vents, if present, with a dry, soft brush.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Use a dry, clean cloth to clean the contacts of the product.
Care of the Liion batteries
•
Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
•
Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
10
English
6
7
2383935
*2383935*
