Idiomas disponibles
Idiomas disponibles
Important safety instructions for installation and use
The installation and electrical connections must only be carried out by qualified technicians, with suitable
equipment and under safety conditions, following the instructions given in this manual.
The system must be installed so that the motor unit is at a minimum height of 2.5 m above ground (or from the
nearest access surface).
All routine or extraordinary maintenance must be performed solely by qualified technicians after disconnecting
the system from the electrical power supply.
If any work needs to be done occupying the system operating space (e.g. cleaning glass, removing fabric, etc.)
prevent all possible activation of the system operating devices or disconnect the system from the electrical
power supply.
Only original parts must be used if any parts need to be replaced. Any use of non-original parts and any
adaptation or tampering will relieve Mottura S.p.A. of all liability for injury to persons or damage to property.
Do not let children play with the operating devices. Keep the devices out of their reach.
Make periodic checks of all mechanical and electrical parts. Take steps to prevent the system from being used if
maintenance has to be done.
During normal system use, monitor its movement. Prevent anyone from entering the system operating space
until it is completely stopped.
Attachments "A" – "B" provide instructions for correct assembly and installation of the tubular motors Ref.
1805M28B and Ref. 1805M35B.
Electrical connections – Recharge of the batteries
The motor must be connected to the electrical grid, to the drive devices, and to any
outside units by trained personnel only.
To recharge the motor use supplied devices or original Mottura only.
If the motor is recharged with not original Mottura devices, there is a potential danger
of explosion of the batteries.
DO NOT work on the motor when it is powered. Before doing any work, disconnect the
system from the electrical grid in such a way that it stays disconnected until all work is
finished.
The motor is equipped with rechargeable Li-ion batteries. To recharge the batteries use the charger ref.
06.E5.1805-51 (supplied) only. If the motor is recharged with not original Mottura devices, there is
a potential danger of explosion of the batteries.
Recharge the motor when the speed decreases or when it stops working (see attachments "C" - "D"). To
recharge the batteries:
1. Connect the charger to the motor as shown in the attachment "C" or "D".
2. Supply power to the charger. When the batteries are low, the LED is red. The led turns green when the
batteries are been recharged.
3. Disconnect the supply power to the charger and unplugging it to the motor.
It normally takes 6 hours to recharge the batteries.
The charger is designed exclusively to recharge the batteries and to power the motor continuously.
When the batteries are fully charged (green LED), unplug the adapter from the motor.
Please note that the old battery cannot be disposed of with non-differentiated urban
waste but must be collected separately in accordance with the regulations set down by
the local authorities.
Assembly and installation
SAFETY RULES
2
