Blumfeldt Heat Guru Plus Manual Del Usuario página 18

EN
18
ASSEMBLY
Note: You will need a Phillips screwdriver for assembly.
1. Turn the main unit (1) over so that the top side is facing down.
2. Fasten the connecting piece (2) to the main unit (1) with the screws (3).
3. Attach the clamp (4) to the connector (2) with the screws (5).
4. Insert the plug and the power cable (15) through the holes in the base
cover (6) and the base (7).
5. Then slide the base cover (6), base (7) and washers (10) onto the main
unit. Fasten the washers (10), base (7) and base cover (6) with the M6*35
screws (11).
6. Clamp the power cable with the cable clamp (8) and the base fixing plate
(16) and fix all 3 parts to the base (7) with the M4*33 screws (9).
7. Drill two holes in the floor and fasten the base fixing plate (16) to the floor
with the M6*70 expansion screws (17).
OPERATION
1. Connect the unit to a mains socket. Make sure that the mains voltage
matches the specified power supply. The light of the LED indication
flashes, indicating that the heater is in standby mode.
2. Press the MODE button on the control panel to turn the heater on. Each
time the MODE button is pressed, the heater will switch to the medium
heat level, then to the high heat level, and finally back to the low heat level.
3. Press the SWING button on the control panel or remote control to swing
the unit back and forth. Press the button again to stop the swing function.
4. Press the TIMER button on the control panel or remote control to set the
timer between 0-9 hours. [0] means the timer is off. Each time you press
the TIMER button, the timer will cycle from [0] to [9]. Press the button
again to exit the timer function.
5. When the device is no longer needed, turn it off by pressing the OFF
button on the remote control or the control panel and disconnect the plug
from the power outlet.