Idiomas disponibles
Idiomas disponibles
Select
the
most
according to the type and/or dirtiness of
the dishes to be washed.
As standard accessory; there is 1 plate, 1
cutlery, 1 glass tray in 500x500 mm size
in the machine.
Select the relevant tray according to the
dishes to be washed and load them
according to the capacities stated on the
chart. Do not start the device without
entirely filling the tray in order to save
detergent and power.
Never change the location of the device
while it is operating.
Be sure that the water input valve is open
before operating the device.
WARNING!!!
NEVER PUT YOUR BARE HANDS IN THE
WASH
WATER.
IF
PROTECTIVE
GLOVES.
DETERGENT WATER ON YOUR EYES.
9. TURNING OFF
The device is turned off by holding down
the ON/OFF button for 2 seconds.
Bring the switch that supplies the device
to "0" position.
Take the washed product out by lifting the
upper cover and close the cover.
Close the water inlet valve.
10.SECURITY MEASURES
If the cover is opened while the device is
operating or if the cover is not completely
closed after it is started, the device will
stop operating. Device will start operating
once the cover is shut.
WARNING: If there are any damages on the
energy input cable or any water leakage on the
release pump, the device needs to be shut down
and an authorized service must be notified.
10.DAILY MAINTENANCE
The wash water must be renewed at least
two times a day or when the water loses
its ability to clean due to dirty particles.
Washing performed with dirty wash water
causes bad washing results, along with
detergent, polisher and power wastage.
Before starting maintenance activities,
turn off the power switch that the device
is connected to.
Be careful so that the dirty water outlet is
not blocked.
Check whether the washing and rinsing
arms can turn easily. Check the water
All manuals and user guides at all-guides.com
suitable
program
NECESSARY,
USE
DO
NOT
RUB
sprays and if they are blocked, clean the
holes with a thin stick.
Leave the cover open after cleaning the
device.
WARNING; In order not to damage the
electrical equipment, clean the device with a
direct or high pressured water.
11.PERIODIC MAINTENANCE( once every
2-3 days)
Never do maintenance while the device is
powered.
As shown in Figure 1, materials that can
cause blocking must be cleaned by taking
out the nozzles of the water sprays.
Clean the outer surfaces of the device
with a wet and soapy cloth. While
cleaning the surface of the device, do not
use materials that can leave marks on the
surface such as detergents, wire brushes
etc. which have abrasive content.
Clean the device warmers with an anti-
lime once a week.
Take out and clean the pump front filter in
certain periods.
If the device will not be used for a long
time, the surfaces need to be covered with
Vaseline in thin layers.
Contact the authorized service in case a
dangerous situation is noticed in the
device. Do not let unqualified people to
interfere the device.
After
a
depending on the hardness of water, the
calcium and magnesium in the water can
cause the forming of boiler scale on the
interior surfaces of the wash tank, boilers
and interior sections of the water pumps
which can affect the devices performance.
For this reason, a boiler scale cleaning
process must be performed by a qualified
technician over time.
Maintenance of the boilers, emptying the
water inside the boiler and pump and
cleaning them must be performed by
qualified people periodically.
If there is a danger of freezing during the
times when the machine hasn't worked for
a long time, the wash pump and boiler
must be emptied.
Contact the authorized service in case a
dangerous situation is noticed in the
machine. Do not permit unqualified
people to interfere the device.
11
certain
operating
duration,
