Idiomas disponibles
Idiomas disponibles
REF. 60022
OPERATION
Switching On/Off
This tool is equipped is equipped with a safety switch to
prevent an accidental starting:
To turn it on, depress the safety switch and slowly de-
press the trigger switch.
To turn it off, fully release the trigger switch.
NOTE! The trigger switch can be used as a variable
speed control mechanism. The higher the pressu-
re on the trigger switch, the higher will be the cutting
speed, while light pressure on the trigger results in a
low speed.
Using the laser guide
1. Draw the line of cut on the material to be cut.
2. Set the miter and bevel angles accordingly before
clamping the workpiece.
3. Press the laser switch to turn on the laser guide.
4. Align the line of cut previously drawn with the laser
beam.
TROUBLESHOOTING
PROBLEM
Rigid sliding movement
Poor cutting performance
Vibration on the saw
Miter angle hard to adjust
5. Turn the saw on and use the saw to cut the wor-
6. With the blade fully stopped, turn the laser guide
NOTE! Never directly point the beam at someone else
or yourself and do not stare into the beam.
Miter cut
1. Move the saw to the desired miter angle.
2. Move with the handle to the miter angle to make
Bevel cut
1. Place the blade to the desired bevel angle.
2. Remain at the left side of the handle while cutting.
Compound cut
1. Select the desired bevel and miter position.
2. Move with the handle to the miter angle to make
MAINTENANCE
• Always be sure that the tool is switched off and
• Regularly clean the tool's air vents with compres-
• Do not use cleaning agents to clean the plastic
• Keep cutting tools sharp and clean. Properly main-
REASON
Locking knob is tightened
Dust accumulation
Saw blade not sharpened
Saw blade not properly fitted
Saw blade is inappropriate
Blade is bent
Saw blade not properly fitted
Saw dust accumulated onto the table
· 11 ·
kpiece once it has reached its full speed.
off once finished.
the cut.
the cut.
the battery pack is removed from the tool before
attempting to perform inspection or maintenance.
sed dry air. Do not attempt to clean by inserting
pointed objects through openings.
parts of the tool, a mild detergent on a damp cloth
is recommended instead.
tained tools with sharp cutting edges are less likely
to bind and are easier to control.
SOLUTION
Loosen the locking knob
Remove dust and lubricate
Place a new blade
Mount again the saw blade
Use a suitable blade
Replace the blade
Mount again the saw blade
Clean dust from the table
