Idiomas disponibles
Idiomas disponibles
REPLACING THE COIN CELL
BATTERY (Fig. 14)
When the remote control and LED
indicators on the gun stop working, the
battery capacity is low.
1. Open the battery cover and remove
the old battery (FIg. 14a).
2. Observing the correct polarity (+
and –), tilt the new battery and
insert it below the two clips in
the battery compartment first,
then push the battery into the
compartment (Fig. 14b).
NOTICE:
Never push the battery directly
into the compartment. Otherwise, the two
clips will be damaged, causing failure of
the gun remote control.
3. Close the cover.
NOTE:
You will need to again pair the
gun with the pressure washer after the
coin cell battery is replaced following
the instructions in the section "Short
Pressure Gun Pairing".
Required Battery
Coin cell (button cell) Battery
WARNING:
used batteries away from children. If you think batteries might have been
swallowed or placed inside any part of the body, seek immediate medical
attention.
This product contains a lithium coin/button cell battery. If a new or used lithium
coin/button cell battery is swallowed or enters the body, it can cause severe
internal burns and can lead to death in as little as 2 hours.
32
56-VOLT LITHIUM-ION PRESSURE WASHER — HPW3200/HPW3200-FC
Chemical Burn Hazard. Do not ingest battery. Keep new and
14a
14b
Model
CR2032
Clips
