Idiomas disponibles
Idiomas disponibles
INDEX
1. IDENTIFICATION
2. DESCRIPTION
3. VIBRATION AND NOISE LEVEL
4. ELECTROMAGNETIC ENVIRONMENT
5. SAFETY PRECAUTIONS AND WARNINGS
6. STORAGE
7. SPECIFICATIONS
8. CONTENTS
9. KITS
10. AIR SUPPLY AND PRESSURE REGULATOR
11. INSIDE THE MACHINE
12. CHECKS BEFORE USING THE MACHINE
13. PREPARATION AND OPERATION
14. MAINTENANCE
15. PURGING OR PRIMING MANNER 1
16. PURGING OR PRIMING MANNER 2
17. ASSISTANCE
18. GUARANTEE
19. MOST COMMON PROBLEMS
20. BREAKDOWN
1. IDENTIFICATION
The HT-40 riveting machine is identified by a
nameplate on the outside with a serial number,
BRALO logo, address, website and CE-UK mark.
BRALO, S.A.
Milanos, 12
28320 Pinto (Madrid)
SPAIN
Tel.: +34 916928285
2. DESCRIPTION
The HT-40 riveting machine is a tool designed
to set structural rivets, collar bolts and Estrubolt
rivets. Ideal for assembly lines.
This is a riveting machine with a lightweight gun
in painted aluminium for effortless operation,
which is connected with a hose to a wheeled
control unit. Inside the control unit are the
drive valve, the air filtering system, the pressure
regulation, the oil and filter tank and two pistons,
one for traction force and the other for recovery
force, the latter is essential for the machine's
recovery.
85-86
MODEL
NUMBER
MANUFACTURED ON
EN
3. VIBRATION AND NOISE LEVEL
The continuous sound pressure level recorded in
13
13
the workplace does not exceed 80 dB, as this is a
13
tool designed to work at low noise levels for the
13
safety of the operator.
13
If all instructions are followed, this is a riveting
14
machine that does not generate any vibrations
14
that could cause harm to the operator.
14
14
4. ELECTROMAGNETIC ENVIRONMENT
18
18
The HT-40 riveting machine is approved to work
19
in industrial electromagnetic environments, it is
19
within the Emission and Immunity limits under the
19
following standards: General Emission Standard
19
- Part 2 Industrial Environment (2007) and
20
the General Immunity Standard - Part 2 of the
21
Industrial Environment (2006) of EN 61000-6-4
21
Electromagnetic Compatibility (EMC) standard.
21
5. SAFETY PRECAUTIONS AND
WARNINGS
Read the entire instruction manual carefully
before installing, operating or repairing this
tool. Keep this instruction manual near the
tool at all times.
• This manual has been written so that
operators can operate the machine and carry
out maintenance work, but they must not carry
out repair work, as only BRALO, S.A. authorised
technicians can carry out these more technical
tasks.
• BRALO, S.A. offers you training and qualified
personnel.
• Any modifications made to the tool by
the customer its the sole responsibility of
the same. BRALO is available to give any
suggestions required before the customer makes
modifications.
• Damage caused by transport or mishandling
is not covered by BRALO's warranty and shall be
borne by the customer.
13
HT-40
Suitable clothing must be worn
to avoid entanglement with the
tool, protective goggles for the
operator and bystanders, and
gloves.
www.bralo.com
