Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
_WARNING:
Do not short battery terminals
by allowing
a wrench
or any other
object
to
contact
both
terminals
at the same
time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands,
rings, etc.
Positive
terminal
must be connected
first to
prevent
sparking
from accidental
grounding.
1.
Lift hood to raised
position.
2.
Disconnect
BLACKbattery
cable (A) then
RED battery
cable
and carefully
remove
battery
from tractor.
3.
Install new batterywith
terminals
in same
position
as old battery.
4.
First connect
RED battery
cable
(B) to
positive
(+) battery
terminal
with hex bolt
and keps nut as shown.
Tighten
securely.
Slide terminal
cover
(C) over terminal.
5.
ConnectBLACKgroundingcabletonega-
tive (-) batteryterminal
with remaining
hex
bolt and keps nut. Tighten
securely
6.
Close
hood.
(Red)
Cable
Negative
(Black)
Cable
TO REPLACE
HEADLIGHT
BULB
1.
Raise
hood.
2.
Remove
bulb holder from the hole in the
backside
of the grill.
3.
Replace
bulb
in holder
and install
bulb
holder securely
back into the hole in the
backside
of the grill.
4.
Close
hood.
INTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly, stop running, or prevent
it from starting.
Check wiring.
See electrical wiring dia-
gram in the Repair Parts section.
TO REPLACE
FUSE
Replace
with 30 amp automotive-type
plug-
in fuse.
The fuse holder
is located
behind
the dash.
TO REMOVE
HOOD AND GRILL AS-
SEMBLY
1. Raise hood.
2. Unsnap headlight wire connector.
3. Stand in front of tractor.
Grasp hood at
sides, tilttoward engine and lift offoftractor.
4. When replacing hood, be sure to recon-
nect the headlight wire connector.
Headlight
Wire
Connector
ENGINE
TO
ADJUST
THROTTLE
CONTROL
CABLE
The
throttle
control
has
been
preset
at
the factory
and adjustment
should
not be
necessary
Check
adjustment
as described
below before
loosening
cable.
If adjustment
is necessary,
see engine
manual.
TO ADJUST
CHOKE CONTROL
The choke control has been preset at the
factory and adjustment should not be neces-
sary. If adjustment
is necessary, see engine
manual.
TO ADJUST
CARBURETOR
Your carburetor
has been preset at the factory
and
adjustment
should
not be necessary.
However,
minor adjustment
may be required
to compensate
for differences
in fuel, tem-
perature,
altitude
or load.
If the engine
does
need adjustment,
see engine
manual.
26
