Idiomas disponibles
Idiomas disponibles
TO OPERATE
MOWER
Your tractor
is equipped
with an operator
presence sensing switch. Any attempt by the
operator to leave the seat with the engine
running and the attachment
clutch engaged
will shut off the engine. You must remain
fully and centrally
positioned in the seat to
prevent the engine from hesitating or cutting
offwhen operating your equipment on rough,
rolling terrain or hills.
1. Select desired height of cut with attach-
ment lift switch.
2. Start mower blades by engaging attach-
ment clutch control.
TO STOP MOWER BLADES
-
Disengage
attachment
clutch control.
,_
CAUTION:
Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the deflector shield
(S) in place.
REVERSE
OPERATION
SYSTEM
(ROS)
Your
tractor
is equipped
with
a Reverse
Operation
System
(ROS).
Any
attempt
by
the operator
to travel in the reverse
direction
with the attachment
clutch engaged
will shut
off the engine
unless
ignition
key is placed
in the ROS "ON"
position.
_IbWARNING:
Backing
up with
the
at-
tachment
clutch
engaged
while
mowing
is
strongly
discouraged.
Turning the ROS "ON",
to allow
reverse
operation
with the attach-
ment clutch
engaged,
should
only be done
when the operator
decides
it is necessary
to
reposition
the machine
with the attachment
engaged.
Do not
mow
in reverse
unless
absolutely
necessary.
ENGINE "ON" POSITION
(NORMAL OPERATING)
TO OPERATE
ON HILLS
_WARNING:
Do not drive
up or down
hills with slopes
greater
than 15 ° and do not
drive across
any slope.
Use the slope
guide
provided
at the back of this manual.
Choose
the slowest
speed
beforestarting
up or down
hills.
Avoid stopping
or changing
speed
on hills.
•
If stopping
is absolutely
necessary,
push
brake
pedal quickly
to brake
position
and
engage
parking
brake.
, To restart
movement,
slowly
release
park-
ing brake
and brake
pedal.
• Slowly
depress
appropriate
drive pedal to
slowest
setting.
,
Make
all turns slowly.
TO TRANSPORT
When
pushing
or towing
your
tractor,
be
sure to disengage
transmission
by placing
freewheel
control
in freewheeling
position.
Freewheel
control
is located
at the
rear
drawbar
of tractor.
1.
Raise attachment
lift to highest
position.
2.
Pull freewheel
control out and intotheslot
and release
so it is held in the disengaged
position.
Do not
push or tow tractor
at more than
two (2) MPH.
To re-engage
transmission,
reverse
above
procedure.
TRANSMISSION
ENGAGED
TRANSMISSION
DISENGAGED
NOTE:
To protect
hood from damage
when
transporting
your tractor on atruck
or atrailer,
be sure hood is closed and secured
to tractor.
Use an appropriate
means
of tying hood to
tractor
(rope,
cord, etc.).
TOWING CARTS AND OTHER
ATTACH MENTS
Tow
only
the
attachments
that
are
recommended
by
and
comply
with
specifications
of the manufacturer
of your
tractor. Use common
sense when towing.
Too heavy of a load, while on a slope, is
dangerous.
Tires can lose traction with the
ground
and cause you to lose control
of
your tractor.
13
