Idiomas disponibles
Idiomas disponibles
_NE
YEAR FULL WARRANTY
-'_
If any part of this Craftsman Router Table is defective in material or workmanship within
one year from the date of purchase, return it to your nearest Sears Parts & Repair Center,
and it will be replaced free of charge.
WARRANTY
SERVICE IS AVAILABLE BY CONTACTING SEARS SERVICE AT
1-800-4-MY-HOME. ®
This warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.
Sears Roebuck and Co. Dept. 817 WA Hoffman Estates, IL 60179
J
General Safety Instructions
for Power Tools
...
Additional
Safety Instructions
for Router Tables
Parts List .................................
Assembly
..............................
Operation
..............................
•
•
•
•
•
•
•
•
12
•
•
•
•
•
•
•
•
14
........
8-11
.....
12-17
.....
18-30
J/k WARNING
nRead and understand the tool manual and these instructions. Failure
I
to follow all instructions listed below may result in serious personal injury.
Work Area
Keep your work area clean and well lit.
Cluttered benches and dark areas invite
accidents.
Do not operate power tools in explosive
atmospheres,
such as in the presence of
flammable liquids, gases, or dust. Power
tools create sparks which may ignite the dust
or fumes.
Keep bystanders,
children, and visitors
away while operating a power tool.
Distractions can cause you to lose control.
Electrical Safety
Grounded tools must be plugged into an
outlet properly installed and grounded in
accordance
with all codes and ordinances.
Never remove the grounding prong or
modify the plug in any way. Do not use
any adaptor plugs. Check with a qualified
electdcian
if you are in doubt as to
whether the outlet is properly grounded.
If the tools should electrically malfunction
or break down, grounding provides a low
resistance path to carry electricity away from
the user. Improper grounding can shock, bum
or electrocute. Grounded tools are equipped
with three conductor cord and three prong
type plugs.
2
Before plugging in the tool, be certain
the outlet voltage supplied Is within the
voltage marked on the nameplate.
Do not use "AC only" rated tools with
a DC power supply.
Double Insulated tools are equipped with
a polarized plug (one blade is wider than
the other.) This plug will fit in a polarized
outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If It still
does not fit, contact a qualified electrician
to install a polarized outlet. Do not change
the plug in any way. Double Insulation []
eliminates the need for the three wire
grounded power cord and grounded power
supply system.
Avoid body contact with grounded
surfaces such as pipes, radiators, ranges
and refrigerators. There is an increased risk
of electric shock if your body is grounded.
If operating the power tool in damp locations
is unavoidable, a Ground Fault Circuit
Interrupter must be used to supply the power
to your tool. Electrician's rubber gloves and
footwear will further enhance your
personal safety.
Don't expose power tools to rain or wet
conditions. Water entering a power tool will
increase the risk of electric shock.
