Idiomas disponibles
Idiomas disponibles
ASSEMBLE THE LEGS TO THE
MOUNTING RAILS (Fig. 3)
The switch spacers are attached to the
router table legs, 2 per leg. Snap or cut
them off before beginning assembly,
and set them aside.
NOTE: Both legs are identical and are
interchangeable
for assembly.
Assembly Hint: It may be easier to attach
the legs if you turn the table upside down
for this step.
1. Position a table leg (2) at one end of
the leg mounting rails, aligning the
holes in the leg with the holes at the
end of the leg mounting rail.
2. Place a 13/64" I.D. x 9/16" O.D.
washer (18) on each of four #10-32 x
11/2"button-head machine screws (23)
and insert the screws through the holes
in the leg and the leg mounting rail.
Figure 3
3. Secure the leg in place with four
#10-32 KEPS nuts (16). "l]ghten the
nuts SECURELY.
4. Repeat for the other leg.
NOTE: Use a screwdriver to hold the
screws in place while tightening the
nuts with a wrench.
ATTACH MITER GAUGE SLOT
INSERT (Fig, 4)
Assembly Hint: It may be easier to install
the miter gauge slot insert if you lay the
table on its back edge for this step.
1. Position the miter gauge insert in the
slot on the tabletop, making sure that
it is centered in the slot and does not
extend past the rounded edges of
the tabletop.
2. From the top side of the tabletop (1),
insert three #10-32 x 5/8" countersunk
Phillips machine screws (20) through
the holes in the miter gauge slot
insert (4).
3. Secure with a #10-32 KEPS nut (16)
and a 13/64' I.D. x 9/16" O.D. washer
(18) on each screw.
13
