Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
THIS UNIT IS INTENDED TO BE USED WITH COLD WATER ONLY! DO NOT USE
HOT WATER IN THIS PRESSURE CLEANER!
Starting Up
After connecting the pressure cleaner to your cold water supply, proceed as follows:
Make sure that the on/off switch is in the off position.
Connect the garden hose to the inlet fitting.
Attach the hose to the gun as per assembly instruction step #1.
Insert the adjustable spray nozzle into the gun as per assembly step #3.
Connect the high pressure hose to the high pressure outlet fitting as per
assembly step #4.
Connect the garden hose to the high pressure washer inlet fitting as per
assembly step#5.
Open the water supply valve completely.
Before turning the unit on, press the gun trigger to bleed all the remaining air
out of the pump and hose.
Start the pressure cleaner by turning the on/off switch to the on position and
squeeze the trigger. REMINDER: Motor does not run continuously, only when
the trigger is squeezed.
WARNING: RISK OF INJECTION! Unit will start spraying when trigger is
squeezed. When turning the unit off after use, high pressure still exists inside
the hose and unit. Point the gun in a safe direction and discharge the excess
pressure. NEVER direct the high pressure water stream at people or animals.
Automatic On/Off
The pressure cleaner is equipped with an automatic on/off switch. The pressure
cleaner will only run when the power switch is in the ON position and the trigger on
the gun is squeezed. When you release the trigger to stop spraying water through
the gun, the motor on the pressure cleaner will automatically shut off. Simply
squeeze the trigger again to resume using the cleaner. To stop using the pressure
cleaner, release the trigger and switch the unit to the OFF position. The unit should
be turned completely OFF while not in use or while unattended.
10
