After Using The Machine; Machine Long Inactivity; Maintenance - Nilfisk-Advance SW4000 Instrucciones De Uso

ENGLISH

AFTER USING THE MACHINE

After working, before leaving the machine, perform the following procedures.
– Turn on the filter shaker shortly, by pressing the lower part of the switch (65).
– Empty the hopper (11) (see the procedure in the previous paragraph).
– Lift the main broom with the lever (63).
– Lift the side brooms with the lever (64).
– Turn off the machine by turning the ignition key (61) to "0", then remove it.
– Engage the parking brake.
– If necessary, charge the batteries (see the procedure in Maintenance chapter).

MACHINE LONG INACTIVITY

If the machine is not going to be used for more than 30 days, proceed as follows:
– Check that the machine storage area is dry and clean.
– Disconnect the battery connector (45).
– (For machines equipped with dust guard system). Empty the tank (24) and clean the water filter (see the procedure in
Maintenance chapter).

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defined by the person in charge of the maintenance.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.
WARNING!
To perform maintenance procedures, the machine must be off, the ignition key removed, and, if necessary, the
batteries must be disconnected.
Read carefully the instructions in the Safety chapter before performing any maintenance procedure.
18
INSTRUCTIONS FOR USE
SW4000 - 1464818000
03/2013