Symbols That Appear On This Manual; General Instructions - Nilfisk-Advance SW4000 Instrucciones De Uso

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ENGLISH

SYMBOLS THAT APPEAR ON THIS MANUAL

DANGER!
It indicates a dangerous situation with risk of death for the operator.
WARNING!
It indicates a potential risk of injury for people or damage to objects.
CAUTION!
It indicates a caution or a remark related to important or useful functions. Pay careful attention to the
paragraphs marked by this symbol.
NOTE
It indicates a remark related to important or useful functions.
CONSULTATION
It indicates the necessity to refer to the Instructions for Use Manual before performing any procedure.

GENERAL INSTRUCTIONS

Specific warnings and cautions to inform about potential damages to people and machine are shown below.
DANGER!
Before performing any maintenance, repair, cleaning or replacement procedure disconnect the battery
connector, remove the ignition key and engage the parking brake.
This machine must be used by properly trained operators only.
Sharp turns must be made at slowest possible speed. Avoid: abrupt turns on slopes, turns when the hopper
is lifted.
Do not lift the hopper when the machine is on a slope.
Keep the batteries away from sparks, flames and incandescent material. Explosive gases are released when
charging the batteries.
Do not wear jewels when working near electrical components.
Do not work under the lifted machine without supporting it with safety stands.
When working under the open hood, ensure that it cannot be closed by accident.
Do not operate the machine near toxic, dangerous, flammable and/or explosive powders, liquids or vapors:
This machine is not suitable for collecting dangerous powders.
If the machine is equipped with lead (WET) batteries, battery charging produces highly explosive hydrogen
gas. Keep the hood open when charging the batteries and perform this procedure in well-ventilated areas
and away from naked flames.
When WET batteries are installed on the machine, do not tilt the machine for more than 30° from the
horizontal plane to prevent the highly corrosive acid from leaking out of the batteries. When the machine is
to be tilted to perform maintenance procedures, remove the batteries.
WARNING!
Carefully read all the instructions before performing any maintenance/repair procedure.
When working near the hydraulic system, always wear protective clothes and safety glasses.
Do not smoke while charging the batteries.
4
INSTRUCTIONS FOR USE
SW4000 - 1464818000
03/2013
Tabla de contenido
loading

Tabla de contenido