Idiomas disponibles
Idiomas disponibles
Never leave the compressor running unattended and follow
the instructions for inflating the object. The inflatable
object could burst and cause serious injury.
While the compressor is running, some parts, pieces and
accessories reach high temperatures. To avoid burns, do
not touch these elements during use.
Before performing cleaning, adjusting, repairing and
maintenance tasks, unplug the power cord.
Replace worn out or damaged parts immediately, so that
the compressor is always in a safe operating condition.
Cleaning:
The compressor must be thoroughly cleaned after each
use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the compressor.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
Keep all the nuts and bolts tight so that the compressor can
work safely.
I
f you remove components or safety devices to carry out
maintenance work, they must be replaced and repositioned
immediately and correctly.
Use only VITO-approved accessories for this appliance or
technically identical parts. Failure to do so may result in
personal injuries or damages to the compressor. If in doubt,
if you lack knowledge or resources, you should contact an
official dealer.
The compressor should only be serviced by the brand's
technical assistance center, or other qualified personnel,
replacing any necessary parts with original parts.
Position the compressor in a clean, dry and well-ventilated
area. Never operate the compressor in damp areas or where
water is splashing.
Use the compressor in areas free of dust, chemicals,
vapours, explosives or flammable gases.
Place the compressor on a flat surface.
Depending on the type of object to be inflated, you can use
the air hose fitting directly on the object or with the
supplied inflation accessories.
Coupling with air hose fitting:
1. Screw the fitting (5) of the compressor onto the valve of
the object to be inflated (e.g. tyre);
Coupling with inflation accessory:
2. Screw on the inflation accessory according to the object
to be inflated;
3. Insert the inflation accessory into the valve of the object
to be inflated.
(5) Inflatable objects with counter pressure (car or bicycle
tyres).
(9,10) Inflatable objects without counter pressure (air
mattresses, beach balls, etc).
(11) Balls.
