Craftsman WEEDWACKER 316.711201 Manual Del Operador página 10

Idiomas disponibles

Idiomas disponibles

I_lib
I WARNING:
Operate this unit only in a well-ventilated
!
outdoor area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
[__J
WARNING:
Avoid accidentally starting the unit. To avoid
serious injury, the operator and the unit must be in a stable
1
position when pulling the starter rope (Fig. 8).
Off (O) / Stop
On ( I ) / Start
STARTING
iNSTRUCTiONS
1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the ON (I) position at all times (Fig. 6).
3. Slowly press and release the primer bulb 15 times (Fig. 7). If fuel
cannot be seen in the primer bulb, press and release the primer
bulb until fuel is visible.
4. Crouch in the starting position (Fig. 8).
NOTE: SQUEEZE and HOLD the throttle control for ALL further steps.
5. Squeeze and hold the throttle control (Fig. 6). Pull the starter rope
with a controlled and steady motion until the unit starts (Fig. 8).
NOTE: This unit uses the INCREDI-PULL
TM
starting system, which
significantly
reduces the effort required to start the engine.
6. Continue to squeeze the throttle control. Allow the engine to
warm up for 30 to 60 seconds.
NOTE: The engine is properly warmed up when it accelerates
without hesitation.
IF... the unit does not start after 10 pulls of the starter rope, begin
the starting procedure with step 3.
STOPPING
iNSTRUCTiONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the OFF (O) position until
the engine comes to a complete stop (Fig. 6).
Starter Rope Grip
Fig. 6
Fig. 7
Throttle Control
Primer Bulb
Starting
Position
Throttle Control
Fig. 8
10
loading