Metabo PowerMaxx BS Instrucciones De Manejo página 7

Keep hands away from the rotating tool!
Remove chips and similar material only with the
machine at standstill.
Dust from material such as paint containing lead,
some wood species, minerals and metal may be
harmful. Contact with or inhalation of the dust may
cause allergic reactions and/or respiratory
diseases to the operator or bystanders.
Certain kinds of dust are classified as carcinogenic
such as oak and beech dust especially in conjunc-
tion with additives for wood conditioning (chro-
mate, wood preservative). Material containing
asbestos must only be treated by specialists.
- Where the use of a dust extraction device is
possible it shall be used.
- The work place must be well ventilated.
- The use of a dust mask of filter class P2 is
recommended.
Follow national requirements for the materials you
want to work with.
LED (2): Do not view LEDs directly through optical
instruments, LED class 1M, classified as per
IEC 60825-1: 2003, wavelength: 400-780 nm;
t =300 µs, 5 lm.
imp
SYMBOLS
V ............ volts
....... direct current
n rated speed
0...............
../min ...... revolutions per minute
rpm ........ revolutions per minute
4 Overview
See page 2.
1 Protective cap/bit clamping bush*
2 LED lights
3 Adjusting sleeve (torque control, maximum
torque)
4 Slide-switch (1st/2nd gear)
5 Rotation selector switch (direction of rotation
setting, transporting safety device)
6 Trigger
7 Battery pack release button
8 Battery pack
* depending on model
5 Use
The machine's multifunctional monitor-
5.1
ing system
If the machine switches off automatically, the
machine electronics have activated auto-
matic protection mode. A warning signal sounds
(continuous beeping). The beeping stops after a
maximum of 30 seconds or when the trigger is
released (6).
In spite of this protective function, over-
loading is still possible with certain appli-
cations and can result in damage to the
machine.
Causes and remedies:
1. Battery pack almost flat (the electronics
prevent the battery pack from discharging
totally and avoid irreparable damage).
If the battery pack is almost flat, it must be
recharged.
2. Long continuous overloading of the machine
will activate the temperature cut-out.
Leave the machine or battery pack to cool.
Note: The machine will cool more quickly if you
operate it at idling speed.
3. If the current is too high (for example, if the
machine seizes continuously for long periods),
the machine switches off.
Switch off the machine at the trigger (6). Then
continue working as normal. Try to prevent the
machine from seizing.
5.2 Battery pack
Charge the battery pack before use.
If performance diminishes, recharge the battery
pack.
The ideal storage temperature is between 10°C
and 40°C.
Removing the battery pack
Press the battery pack release (7) button and
remove the battery pack (8).
To fit
Slide in the battery back (8) until it engages .
5.3 Setting the direction of rotation, engag-
ing the transporting safety device
(switch-on lock)
Do not activate rotation selector switch (5)
unless the motor has completely stopped!
Actuate the rotation selector switch (direction of
rotation setting, transporting safety device) (5).
See page 2.
R = Clockwise setting
L = Counter-clockwise setting
0 = Middle position: transportation safety
device
(Switch-on lock) set
ENGLISH
ENG
7