Idiomas disponibles
Idiomas disponibles
Do not use the vacuum cleaner without a dust bag and/or filters.
If the opening, which sucks air, hose or telescopic tube are clogged,
you should immediately turn off the vacuum cleaner. Before restart-
ing the vacuum cleaner, first remove the blocking item.
Do not use the vacuum cleaner too close to heaters, radiators, cig-
arette butts, etc.
Before using the vacuum cleaner, remove sharp objects from the
floor to avoid damaging the dust bag.
Do not collect fine particles such as: flour, gypsum, printer toners,
etc., as this may clog filters and damage the vacuum cleaner.
Make sure that extension tube is fully withdrawn before you put
away your vacuum cleaner either in vertical or horizontal position.
NOTE:
Batteries are not included with the product. You need to purchase
batteries to power the control unit integrated in the handle (2 x 1.5V
AAA batteries).
Amica S.A. hereby declares that the type of radio emitting equip-
ment, vacuum cleaner, models VM 4011/VM 4012/VM 4013/VM
4014 comply with Directive 2014/53/EU. The full text of the EU dec-
laration of conformity is available on our website at: www.amica.pl.
Frequency bands
The maximum power of a
radio signal transmitted in a
frequency band
SPECIFICATION:
Power specification:
Nominal power:
Maximum power:
Net weight:
YOUR APPLIANCE:
1. Turbo brush
2. Metal tube
3. Dust bin
4. Hose connection
5. 2in1 crevice and book attachment
6. Dust container release button
7. Rear wheel
8. Speed control buttons
9. Power cord retract button
10. Hose
11. Handle controls
12. Parquet brush
13. 2in1 allpurpose suction brush
Note! Figures are for illustrative purposes only. Individual models
may vary.
* depending on model
433.050434.790MHz
﹤20dBm
AC 220240V / 50Hz
800W
900W
4.5 kg*
6
9
11
OPERATE THE APPLIANCE:
Before first use
Always unplug the appliance before attaching or removing attach-
ments!
•
Before using this product, please install the batteries in the
battery compartment of the control handle. Carefully open
the battery compartment cover and insert two 1.5V AAA bat-
teries. Close the battery compartment cover. Then connect
the vacuum cleaner to the mains socket and press the on/off
button on the vacuum cleaner to start it. Then press any con-
trol button and now the appliance can be controlled remotely
from the handle.
•
Note: When inserting batteries observe correct polarity of
battery "+" and "" terminals. If the vacuum cleaner is not
used for a long time, remove the batteries from the battery
compartment of the control handle.
Control speed using the handle
•
The remote control handle has three buttons for operating
the vacuum cleaner. The "+" and "" buttons can be used to
adjust the suction power of the vacuum cleaner. Use the but-
ton on the control handle to turn off the appliance.
•
Note! No indicator on the remote control handle lights up
when you press any button. For battery replacement, see
chapter "Before using for the first time."
•
Note! The remote control handle will only work if the pow-
er button on the appliance is pressed. If the vacuum cleaner
does not respond to the control panel buttons on the handle
despite the batteries being fully charged, you must pair the
control panel with the vacuum cleaner. See the section: "Pair
the handle control panel with the vacuum cleaner."
Pair the handle control panel with the vacuum cleaner.
•
Pair the handle control panel with the vacuum cleaner: Insert
the new batteries into the handle battery compartment (see
section "Before first use") and connect the vacuum cleaner
to the wall power outlet. Turn on the vacuum cleaner using
the on/off button on the appliance. Hold down the "+" and
"–" buttons until the indicators on the screen light up in se-
quence. Press the remote control button in the handle. Now
the handle control panel is paired with the vacuum cleaner.
Assemble the appliance
Always unplug the appliance before attaching or removing attach-
ments!
•
Insert the end of the hose into the inlet opening.
7
3
7
8
2
5
4
10
1
13
12
EN
