Idiomas disponibles
Idiomas disponibles
4.3. Inserting batteries in the remote control
Remove the battery compartment cover on the back of the remote control.
Insert two LR03 (AAA) 1.5 V batteries in the battery compartment of the remote control. Check
the battery polarity (see label on the bottom of the battery compartment).
Close the battery compartment.
NOTICE!
Risk of damage!
The remote control can be damaged by leaking batteries if not used for a long pe-
riod of time!
Remove the batteries from the remote control if the device is not going to be
used for a long period.
4.4. Connecting the antenna
Your smart TV supports different antenna signals.
You can input the following image signals to the television through the socket labelled ANT.:
• Via analogue cable/an analogue house aerial
• Via a DVB-T2/ DVB-T
• Via a DVB-C
2
connection (digital cable connection)
Insert the antenna cable either from the house aerial/analogue cable connection, a DVB-T anten-
na or the DVB-C connection in the antenna socket on the Smart TV.
You also have the option of connecting a digital satellite system to the socket labelled LNB.
Screw a coaxial antenna cable's F connector onto the connector on the Smart TV.
To receive encrypted/subscription channels you will need to use a CI module (Con-
ditional Access Module) and an appropriate card. Insert a CI module (available in
specialist shops) in the slot provided for this purpose on the left-hand side of the
device (COMMON INTERFACE). You can then insert your provider's card in the CI
module.
4.5. Connecting the power supply
Connect the supplied power cord to the mains connection socket of the device.
Connect the mains plug on the device to an easily accessible 220 to 240 V ~ 50 Hz mains socket.
4.6. Switching the Smart TV on and off
The device will be in standby mode as soon as you have connected the mains plug to the mains
socket.
To switch on the device, press
− on the remote control: the standby/on button, one of the number buttons or one of the
buttons;
P
/
− on the device: the button
Use the standby/on button on the remote control to switch the device back into standby mode.
The device will be switched off, but will continue to use power.
2
This service must be available in your region.
8
2
antenna or
.
