Idiomas disponibles
Idiomas disponibles
Some faults that could occur are indicated for the Up/Down
control panel on the LED signal lamp, and for the Memory
control panel on the display.
The tables below should help you to determine the cause and
correct the error or fault.
6.3 Error messages
The tables below should help you to determine the cause and
correct the error or fault.
6.3.1 Fault rectification
Desk does not
move
Desk only moves
down slowly
No power supply
Loose or no connection
to the drives/side parts
No connection to
manual switch
Max. lifting force
exceeded
Max. switch-on time
exceeded
Drive defective
Controller defective
Control part defective
Controller expects rein-
itialisation
6 Errors and faults
Insert mains cable check plug-
in connection at controller, if
necessary
Check or establish plug-in
connections of the motor
cables to the controller and to
the drives
Check or establish plug-in
connection to the controller
Reduce weight
Controller reactivates itself
after approx. 3 minutes.
ATTENTION! The max.
movement period of 2 minutes
is only available again after a
rest period of at least 18
minutes
Contact customer service
Contact customer service
Replace control part
See Up/Down control panel on
page 26
See Memory control panel on
page 28
EN
35
