First Use; Aligning The Motion Sensor; Setting Light Time (Time); Adjusting Sensor Sensitivity (Sens) - LIVARNO LUX LSLB 10 A1 Manual De Instrucciones

 Close the junction box (11) by screwing the cover again tightly with the
four screws that you previously removed. When closing the junction box
(11), ensure that the sealing ring lies correctly in the groove. Otherwise, IP
protection is not guaranteed.
 Then attach the LED spotlight to the mounting bracket (3). To do so, use
the previously removed screws (2) and washers. Make sure that the flat
washers are located between the LED spotlight (1) and the mounting
bracket (3). The spring washers must be between the screw head and the
mounting bracket (3).
 Switch on the circuit.

7. First use

7.1. Aligning the motion sensor

Make sure that no movements that should not be detected (for
example, on the pavements or streets) occur in the detection
range of the motion sensor (4).
It is best if you set the light sensitivity of the motion sensor (4)
during the lighting conditions when the LED spotlight is supposed
to be active.
 Align the motion sensor (4) so that it can capture the desired range as
well as possible. The view must not be obstructed by objects or anything
else.
 You can align the motion sensor (4) horizontally by turning it.
 To align the motion sensor (4) vertically, you must first loosen the locking
screw on the adjustment joint (8). If the motion sensor (4) is located in the
desired position, you must tighten the locking screw on the adjustment
joint (8) again.

7.2. Setting light time (TIME)

You use the TIME control (7) at the bottom of the motion sensor (4) to set
the light time (approx. 10 seconds to 4 minutes). Turn the TIME control (7)
clockwise (+ direction) to increase the light time or anti-clockwise (-
direction) to reduce the light time.

7.3. Adjusting sensor sensitivity (SENS)

You use the SENS control (6) at the bottom of the motion sensor (4) to
adjust the sensor sensitivity. Turn the SENS control (6) clockwise (+
direction) to increase the sensitivity or anti-clockwise (- direction) to reduce
the sensitivity. The higher the sensitivity, the greater the detection range (12
metres at the most).
LIVARNO LUX LSLB 10 A1
English - 19