Idiomas disponibles
Idiomas disponibles
•
To engage the parking brake, push the large
pedal (A) forward until the latch bracket engages
the latch pin.
•
To disengage the parking brake, push the small
pedal (B) of the latch bracket and let the large
pedal (A) and the small pedal (B) move back
slowly.
To disengage and engage the drive
system
CAUTION:
engage the drive system when the
product is parked on level ground.
If it is necessary to move the product by hand, with
the engine off, the drive system must be disengaged.
The drive system is disengaged and engaged by the
bypass valves. The bypass valves are found on the
front of each transmission.
Follow the procedure below to disengage the drive
system.
1. Park the product on level ground and stop the
engine. Do not engage the parking brake.
2. Set the cutting deck to the lowest position.
3. Move the bypass levers on each side of the
product.
4. Push the 2 bypass levers rearward.
5. Push the product by hand.
2281 - 001 - 03.11.2023
A
B
Only disengage or
CAUTION:
control levers.
6. To engage the drive system, push the bypass
levers forward.
To set the cutting deck in transport
position or mow position
The cutting deck must be in transport position during
transportation.
•
To set the product in transport position, push the
deck lift pedal (A) forward until the cutting deck
latches in the transport position.
B
•
To set the product in mow position, push the
deck release pedal (B).
To set the cutting height
1. Set the cutting deck in transport position. Refer
To set the cutting deck in transport position or
to
mow position on page 13 .
2. Turn the cutting height adjustment knob.
a) Turn clockwise to increase the cutting height.
b) Turn counterclockwise to decrease the
cutting height.
3. Lower the cutting deck into mow position. Refer
to
To set the cutting deck in transport position or
mow position on page 13 .
Cutting height setting
1
Do not push the
A
Cutting height, in./cm
1.5/3.8
13
