Kenmore 253 Serie Guia Del Propietario página 14

TO REMOVE FREEZER DOOR:
1. Remove the toe grille (see "Outside" in Care and
Cleaning Section).
2. To discor_nect water line, grip tube firmly in left hand and
use toot (located in bag under toe grille) to push in on
gray collar to release water' connector (Figure 1),
Male
Connector
W_tet Une
Connector
Hinge
Cover
Figure 2
3. Remove screw to detach lower hinge cover (Figure 2).
4. To disconnect wiring harness plug connector, place your
thumbs on the flat sides of each connector' piece. Bend
both parts back and forth Then with a firm grasp, pull
the two pEeces apart as shown (Figure 3)..
Figure 31
5. Place a strip of tape along door bottom, over lower
hinge and up the side of the door_ This will hold hinge in
place when door is removed (Figure 4).
6 Loosen, but DO NOT REMOVE, bottom lower hinge
bolt, Remove top lower hinge bott (Figure 4).
7_ Remove top hinge cover by filling back of cover and
sliding forward Remove screws mounting hinge
bracket to cabinet, Hold bracket when removing last
screw; door closer mechanism places mild spring tension
on hinge DO NOT remove hinge bracket from door.
& Carefully lift door up and off loosened lower hinge bolt
(Figure 4)
TO REMOVE REFRIGERATOR DOOR:
1.. Remove top hinge cover by lifting back of cover and
sliding forward, Remove screws mounting hinge
bracket to cabinet. Hold bracket when removing last
screw; door closer mechanism places mild spring tension
on hinge. DO NOT remove hinge bracket from door.,
2 Loosen, but DO NOT REMOVE, bottom lower hinge
bolt. Remove top lower hinge bolt
3. Carefully lift door up and off loosened lower hinge bolt.
Store doors in a safe place until refrigerator is moved to
desired location. Keep all hardware for reinstallation.
TO REINSTALL FREEZER DOOR:
1_ Position door on unit and tighten screws.
2 Reconnect the wiring connector', making sure it is locked..
To prevent electrical shock, fold wires
as shown in Figure 2. Make sure male connector
from door is pointing up. Insert tubing from door
through access hole in lower hinge cover. Position
cover over wires, ensuring they are not pinched or
exposed. Install screw to attach cover..
3._To reinstall water line connector, push door tube firmly
into connector until connector touches the black mark on
the tube and stops (Figure 5).
r'!_ This step is critical to ensure that the
water line does not leako
Water Une
_G ir_y r Connector _ka= _
Water
L from Door Une --
Figure 5
TO REINSTALL REFRIGERATOR DOOR
To reinstall refrigerator door, reverse instructions used to
remove door.
14